New pen hand After the general pen hand Sheung Shui can be used normally, without such individuals take open blisters said new pen. Of course, sometimes there will be no water or touch pen nib dry conditions, this time a little treatment is necessary a. Generally require cleaning after the poor to buy back the ink pen, because some pen nib tested at the factory before or after the customer counter test pen ink is not cleaned in a long time, the composition of ink condensation, blocking pen nib the ink introduction groove, it will lead to poor water. This situation needs to be removed nib, into the warm water (avoid hot water) to soak for half an hour and then dry, installed after the general can be used normally. If that does not extend the soaking time. Or not, then you need to remove the nib metal sheet, and then wash the ink introduction groove and the entire capillary structure of the tongue on the back of the pen with a small brush (that is, plastic tip section above those slits). Water ring true there may be reasons for the tip itself. One is the tip of the nib pens narrow seam, this time can usually write when writing posture will tip a little harder under pressure, keeping one or two seconds, or may be a thin blade expansion joints pen, but must be careful. The second reason is that the ink introduction groove is too narrow, this time on the need to expand the guide with a thin blade ink tank also have to be careful. Some new pen, just beginning to have some water with poor, it is because the new pen factory has always been like this, do not be too nervous. Write two or three days later, written to grind along, I will write a lot of good. Maintenance When writing, should some of the manuscript paper underlay to enhance the flexibility of the tip, reducing friction. Do not tip in the metal and other hard materials writing, to prevent damage to the pen tip. Avoid daily use different inks mix, in order to avoid precipitate blockage pen. Pens should be cleaned once every month or so to keep the ink flowing water, such as using carbon ink should more cleaning must be washed clean. Pen such as long-term need, should be washed saved. And do not use excessive force when writing. Wash General cleaning time can be repeated until the discharged water drainage water clean and dry. If the interval is longer or intend to wash pen wash archive, you need to disassemble the parts are clean. Preliminary apart and divided into five parts: nib, converter (the ink / ink sac), hold a pen, cap, pen. The latter two generally do not have to cleaning. The metal part of the tip of the tongue and pen (the ink structure) should be further apart, rinse the tip sheet metal, and the entire structure of the ink can be an old toothbrush to scrub carefully, and then placed in warm water to soak overnight. After cleaning dry all parts, and so on can be installed completely dry storage. Of course, different pens in different structures, not all pens are available apart, for it is difficult to split the pen, can only use the first method of cleaning, and not forcibly dismantle damage pen. It should say something, there is a known "calligraphy pen" elbow pen with writing stroke thickness changes in the larger features. In use, the pen down some strokes on rough, slightly larger write word; pen erected some fine strokes on writable smaller words. Expressive pen is stronger than a normal pen, used to write envelopes larger fonts. But this pen to write a certain degree of difficulty, beginners should not use it to practice calligraphy. Finally, there is a little special attention: the pen must not be cleaned with boiling water or hot water, otherwise it will damage the pen. In particular, there are some well-known brands will use a pen called "celluloid (celluloid)" pen made of a material, such as Pelikan, etc., this material water will cause serious injury! And do not let the water run into the tip, it may cause the pen color lighter or can not write.